|
EE-10 PRODUCT
APPLICATION
Data
Sheet | Product Application
SEE
MATERIAL
SAFETY DATA SHEET BEFORE HANDLING THIS PRODUCT
SURFACE PREPARATION:
Steel surfaces are to be abrasive blasted with chloride free
abrasive. Exterior applications to SSPC SP-6 Commercial gray
metal finish. Immersion applications to SSPC SP-5 White metal.
Grind flat all burrs, weld seams, radius sharp edges. Fresh
blasted surfaces to be primed with ARCOR™ EE-10 or ARCOR™ EE-31
or 31.1.
Concrete surfaces should be
degreased if oil and grease contamination is present. Degreased
surface shall be high pressure washed, acid etched and high
pressure washed again so surface is clean and free of all
grease, oils and surface laitance. Existing coatings should be
abrasive blasted to clean concrete.
MIXING:
Thoroughly mix Activator into Base with mixing stick or drill
with low speed mixing blade. Mix by Volume 4 parts Base to 3
part Activator or by weight 100 grams base to 64 grams
activator.
THINNING: Never thin.
APPLICATION:
By brush use medium to stiff bristle of sufficient quality that
bristles do not pull out and stick in coating. Trim or tape to
<1” nap.
Roller use good quality 1/8” nap, 1/4” on concrete.
Plural Spray use .017-.019 tip, 2,000-2,500 PSI, Heat to 120ºF
Base, 100ºF Activator.
Airless Spray use .017-.021 tip, 2,000-2,500 PSI (Caution: Short
Pot-Life)
Conventional Spray: Not Recommended
All spray equipment should employ traps to prevent water and oil
from contaminating coating and screens to
prevent particulate contamination.
APPLICATION TEMPERATURE:
Material: Keep between 55 to 95ºF(13 to 35ºC). Substrate : Keep
between 45 to 105ºF(7 to 40ºC). The difference in temperature of
the substrate and the coating should never exceed 10ºF (5ºC).
OVERCOAT/CURE TIME:
Brush or Roller recoat between 6 and 14 hours at 77ºF (25ºC).
Spraying recoat between 3 and 14 hours. Full cure before
immersion 7 Days at 77ºF. Force Cure: 12 hours at 150ºF (66ºC);
6 hours at 200ºF (93ºC).
CLEAN UP: M.E.K. or similar
WARNING: Base contains
epoxy resin. Activator contains alkaline amines, a strong
sensitizer. May cause skin irritation, sensitization or other
allergic responses. Use with good ventilation, particularly if
heated or sprayed. Prevent all contact with skin or eyes. Wear
protective clothing, goggles, gloves or barrier creams. Keep
containers closed when not in use. Wash thoroughly after
handling. In case of skin contact immediately wash with soap and
water. In case of eye contact, flush with water for 15 minutes.
If irritation persists seek medical attention.
|
